Well, the dryer has been disassembled and vacuumed, the dead coil removed, the new coil swapped in, ready to reassemble as soon as the new belt arrives. I was surprised how much of the brown shmutz in the heater was just ash from the coils - it dusted off quite shiny after I replaced the coil.

Before

busted heating element before

After

repaired heating element

I’m a little worried about the visibly duller part of the heater assembly, hopefully that won’t absorb too much heat - I tried to cluster the coils a bit looser there to compensate.

It’s even visible on the reverse side.

dull area where burn happened

Either way, I’m reassembling tomorrow when the new belt arrives.

dryer interior

  • Seathru@beehaw.org
    link
    fedilink
    English
    arrow-up
    2
    ·
    1 year ago

    Getting all the old grease off isn’t super important. You mainly just want to get it clean enough to make sure the bearing surface on it and the ball on the back of the drum are smooth and not getting scratched/galled up.

    • Pxtl@lemmy.caOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      That’s what I’d assumed. Wipe it out with something lint free to make sure there’s no grit, then add the new grease.

      • Sam Vimes@beehaw.org
        link
        fedilink
        arrow-up
        1
        ·
        1 year ago

        Some greases are incompatible, and not cleaning thoroughly causes them to react chemically and cause issue, but unless you’re in that situation, you don’t need to clean super well.