My prints get very good adhesion to the bed, especially when doing prints with large adhesion areas. So good, that after the print is done, I actually have to wet the surface with alcohol and put it in the freezer for it to let go! (edit: I print with PLA)

My question is, if the adhesion could be a bit less violent, if I lower or increase the bed temperature? I have an ender 3 v2 with the original glass bed (it has some black layer on top of the glass).

I know that there are tons of alternative beds that I could buy, but I’d rather keep this bed if I can counter the too strong adhesion

  • HewlettHackard@lemmy.ca
    link
    fedilink
    English
    arrow-up
    3
    ·
    9 months ago

    Yup. My kid found the idea hilarious when I explained why I’d swiped a washable glue stick from the arts and crafts box.

    It hangs on well, but also makes removal easier.