You and I and everyone on Lemm are a rounding error.

There was also no reddit migration.

The amount of waste and time it takes are downright insulting

That’s capitalism - it’ll gladly sell you even its own criticism

Small steps like what? There’s no small steps in changing lifelong OS

I did, check my comment.

Completely new and dried for 24 hours in a dedicated dryer. Thanks.

SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

Yes, this is probably adding to the situation.

I’m in the same boat. I’d like to have something like this integrated with Home assistant but Grocy is just ludicrously complex. It’s like SAS for your fridge, only more complex. With rude developers who always know better than everyone else.

I have absolutely no idea how Brave got the reputation it has. It’s business model is disgusting and extortionate, it’s like paying for warez. Been clear as day since day one.

For me the responsivity of Klipper UI was reason enough. Octoprint is unbelievably slow on the same hardware. The other thing was ease of configuration - no firmware compilation and flashing necessary. And the third is the actual printing performance - Octoprint has a really bad implementation of the actual print data transfer, and the serial interface routinely chokes on fine data such as arcs. That never happens with Klipper, even at much, much higher print speeds.

No, not yet. Weird, I know. No client has this feature AFAIK.

VM or container? VM is easier and can be usually configured even via Proxmox GUI (Hardware - Add PCI). Various OSes need various levels of effort. Some Linux distros don’t need any more config, Windows on the other hand required a custom GPU ROM on my system to work.

This can be done even with a single GPU, even the built in iGPU.

Yes. I think wifi trigger didn’t require confirmation even in 16 but to answer your question, yes, wifi can trigger automation without confirmation.

yeah, thank you. it looks like mods already took the extra ones down. the instance is in weird state right now, stuff is kinda broken for me, i can’t delete them myself

i don’t even see those posts under my Posts at all (in fact no posts are listed there at all).

I didn’t, Lemmy.world was down and then it added this three times. Sorry but not not my fault :)

I have transcoding working in LXC with Quicksync on the Intel CPU. It works well. Can be done.

I have transcoding working in LXC with Quicksync on the Intel CPU. It works well. Can be done.

I’ll probably buy more of this pink ABS, I find it very pretty