I’d never realized how convenient/natural a joystick is for adjusting your side mirrors. I’m not even sure my wife has the reach to both press a touchscreen in the center console and have her head in driving position to adjust the mirrors with real time feedback. Even I’d hate to have to tweak a mirror while driving with a touchscreen.

The implication is that it’s your own blood, but I like the planning/forethought. I think you’ll be going places. Probably at a run.

deleted by creator

There are a lot of never-maskers out there, but I’d say that I’ve seen at least an order of magnitude increase in general usage even years after the lock downs and mandate have been lifted.

Feel the hate. Let it flow through you.

Oh, I didn’t mean to come off as dissing Prusa in general. I ponied up for an XL and it’s night-and-day better than any previous printer I’ve owned.

If this was during an auto level, it’s my humble opinion that this is a manufacturer’s defect in the machine that caused the damage. There should be proper coding to ensure that any increase in sensor pressure by (delta p) halt that machine and that there should be a pressure offset in the sensor such that a loss of signal or anomalous zero reading or lack of reading is done prior to levelling to ensure that a sensor failure has not occurred. My XL freaks out if a fan isn’t spinning at the right speed, so they clearly know that a nominal operational check before the print starts is proper engineering design.

Of course you won’t get anywhere. Unfortunately, a lot of 3D print failures really are user error so I suspect that’s their default response and it takes them a good deal of proof to push them of that mark.

Not to defend them or minimize the corporate stupidity, but it sounded like there were less than 100k people affected out of tens of millions (100m?) accounts. I get that it was a big deal for those affected, but a 0.1% outage doesn’t seem “major”.

Unclear? They’re putting it on [aka: holding it] wrong. User error.

Lets hope, for Apple’s sake, that this isn’t a Q2 Elite Strap debacle.

But, also, this describes every response to a ML prompt.

The description of an unexpected/(impossible) orientation for an on road obstacle works as an excuse, right up to the point where you realize that the software should, explicitly, not run into anything at all. That’s got to be, like, the first law of (robotic) vehicle piloting.

It was just lucky that it happened twice as, otherwise, Alphabet likely would have shrugged it off as some unimportant, random event.

Exactly. They all have to have hardware ids and starlink already geofences the consumer versions.

XL feels like using cheat codes.

On the flip side, global banking processes something like 5+ orders of magnitude more transactions than ETH, so even at the low end it’s 1000x more efficient than the most well known POS coin.

I had nothing to do with it, damnit.

If you print with incompatible filaments (materials which don’t bond/adhere) you can get cheap, nearly perfect breakaway supports. I’ve done some rocket parts on my PrusaXL and it’s certifiably magic.

TBF, if you’re really, really good at throwing feces, civilization sounds like a poor way to maximize the value of your skill. 🫤

Baboo?!

I’m pretty sure that middle bit is like a springform pan. The handle is not solid - you squeeze it to make it sit in the waffle maker but when you remove it, it opens a bit to release. I have no room for this in my kitchen but am intensely intrigued. I might buy a new house so I can get a bigger kitchen and have a place for this.

That puts a smile on my face.