• 4 Posts
  • 85 Comments
Joined 1 year ago
cake
Cake day: June 16th, 2023

help-circle
  • RF only has 2 components, Phase (frequency) and its amplitude. For Analog FM radio, you have a center frequency you tune to. The variance from the center frequency (phase) is the amplitude of the carried signal. For digital signals, you will have specified offsets from the center that represent specific binary codes.

    Edit: as others have said, the tuning and demodulating are 2 different steps. Step 1 tune, When you tune you take the signal centered at the carrier, what the dial on your radio says, and recenter it at 0. Step 1 is the same for pretty much everything RF. The output is “base-band”. You aren’t going in and out of tune because for each center frequency, there will be an agreed variance (band width) allowed for the channel. The tuner captures this entire range and this is what is then demodulated in step 2.


  • Not my area of expertise, but these are my thoughts on the subject.

    If you want mechanical clips on the connector assembly itself, you are probably going to want to stay away from mezzanine or back plane connectors. I usually associate these larger mechanical standards where the card itself has the mechanical fastening with screws, either to a chassis (backplane) or to the other board (mezzanine). You’ll probably find more luck with edge connectors, but that looks like another beast.

    You also need to make sure you use something designed for multiple cycles if you plan on swapping frequently.

    If I was looking for something I would just brows samtech, molex, or just digikey and filter until I find something that suites my needs.

    For hot swap, you also have to make sure you have something that is designed for that, usually that means some longer pins on ground to make sure you’re not having any surges on data lines.