It helps a lot when wanting to play on the deck while also charging it.
It helps a lot when wanting to play on the deck while also charging it.
Did I hear a rock and stone?
I picked up Tunic on the summer sale and am finishing that up.
Tendon after 6 or so hours simmering or 1 hour in a pressure cooker and you got my favorite pho add in.
Only the headphone jack crackle issue mentioned.
It depends more on how much time you want to spend on post processing and how detailed the part is. Teller layers means more time spent filling and smoothing.
You can print at .2 layer height with a .6 noz and benefit from a thicker line width, giving you stronger parts but the overall time to print will still be similar compared to a .4 noz.
If your options are limited, it might be helpful to list them.
Even the steam deck’s touch pads could be moved up more imo however, these look to be pretty much unusable.
+1 for display fusion.
Don’t rule out the wire behind the dash. I was experiencing similar behavior until my phone just didn’t connect but still was getting power from the port. Turns out the wire connecting the USB port and the head unit was faulty. If I wiggled the wire on the end connected to the head unit then it worked like normal.
Flex seal or nothing.
Food Wishes is the GOAT.
Please provide measurements.
No, comparisons should be of relative price and performance class not naming conventions.
Gotta make sure everything is locked, helps with pooping.