Isn’t the same true in the EU, then?
Isn’t the same true in the EU, then?
You also don’t need to show any ID for a business to meet “know-your-customer” regulations. Can you get a phone number without revealing your identity?
To be fair, “merging with” doesn’t specify which one will be managing the other. Unlike “merging into”…
I believe the same is true in the US.
They’re targeting people selling stolen credit cards and drugs, who are advertising on telegram. Your friend (SWIM?) is fine.
I tried printing a disk with the bed at 70c and it looks better. Going to try with it even higher. This sheet has a +0.350 z offset compared to my normal PEI sheet, so that might contribute to low heat conduction.
It was out of mind until I got this new build plate with a fancy texture that I want to imprint on my prints.
This is PLA, I can’t get PETG to stick to the “PEO” bed plate.
Thanks, now I’m hungry
I tried adjusting the z offset to raise the nozzle, but it didn’t help.
My bl-touch mount broke so I’ve been doing manual bed leveling for a while. I just finished printing a 185x185mm part (half of a dactyl keyboard) and the first layer looked great from the top.
Edit: I also deleted the old bed mesh from my klipper config when the bl-touch broke
40/200 looks the same as 60/220. I can try 60/210 but I don’t think it will be any different.
It’s hot - 60 bed, 220 nozzle. I’ll try 40/200
Layer adhesion is great.
No, this pattern isn’t coming from the bed. The bed actually has a polygon pattern that I’m trying to get the plastic to pick up. Sellers on Amazon/ebay/Ali are calling it PEO, but it’s really just PEI with a fine texture that diffracts light. The pattern from the bed comes through really well on the perimeter of anything I print, but not the center.
I forgot to mention, but I also played with the extrusion multiplier (both directions) and it didn’t make a difference. I’ve also gone through the klipper docs and TeachingTech’s calibration guide, the printer is fairly well calibrated at this point.
If you need to replace a cheap nozzle after each medium-sized print with abrasive filament, then I’m thinking print quality will suffer towards the end of a larger print (like >250g, but definitely >1kg). Not having to replace nozzles mid-print makes the $70 nozzle seem like a better deal. Depending on what you print and how much you print, of course.
Depending on how the contract was written, running a clamav scan periodically may have been sufficient.
If I misunderstood your post, it wasn’t intentional. Would you mind elaborating?
Either way there are a lot more contexts where one can use slut and not be shitty.
True, but I don’t think that’s the case here.
There’s no “punching down”, unlike with the antiquated ‘R’ word…
Women can’t be “punched down” on? News to me…
That depends on your OPSEC.