First time arch installer here. I just installed arch with grub on a uefi laptop. Everything seemed fine until I rebooted and ended up in uefi settings instead of grub. The grub entry shows up in the boot options but the computer doesn’t seem to care. What could be wrong?
I dont know what information is useful to narrow the problem down so just tell me what logs are necessary an I’ll post them.
Edit: I tried installing using the archinstall script in case I misunderstood the install instructions, but still not booting. Tried both grub and systemd-boot. The laptop is an Asus vivobook S 14 model K3402Z and even though I have been running fedora on it for the last year I believe the issues have something to do with the laptop hardware.
Edit 2: The issue has been resolved. Turns out the step that ruined the install was when I formatted the NVME drive according to this section of the wiki it messed something up, so reverting that fixed everything.
My first guess would be either messing up the paths for grub-install and/or grub-mkconfig, or just forgetting grub-mkconfig altogether. Grub should “just work” as long as those commands were run properly and you aren’t using Secure Boot.
I have mounted my EFI partition to
/mnt/bootand after chrooting into the root directory I rangrub-install --target=x86_64-efi --efi-directory=/boot --bootloader-id=UEFI-GRUB. Then I rangrub-mkconfig -o /boot/grub/grub.cfg. Is there anything wrong with any of these commands? I got no errors when I ran them.They look fine to me. It might be something in your firmware, laptops can be a little fiddly. I’d try the steps here for an alternate boot path first, and if that fails check here for other methods that may apply.
Another great resource is the Arch Wiki category for laptops. If your model has a page, it should help with any weird configuration issues.
Tried the archinstall script instead and still nothing. Couldnt find my laptop on that page unfortunately but other Asus laptops seem to have some similar issues with the bootloader. Might have to just give up and install fedora again because this sucks.
is secure boot enabled in the firmware?
It is possible that you have a signed grub binary installed but the module signing is not yet rolled out.Edit: my mistake: if you are using grub with shim then all the necessary modules need to be baked into the grub binary. maybe grub was not installed correctly?