Other than some shelves that I made for my office. This is the first piece of furniture I’ve ever made. Lots and lots of mistakes and do-overs. Still, I think it turned out pretty good.
Coffee table. 2 36"x36" sheets of birch ply, with 1/8" Poplar hobby boards glued/nailed to it in the design. The ply was stained with homemade Iron Acetate stain. Then epoxy was poured onto the recessed parts and in all the cracks. Then the whole thing was sanded again and covered in many coats of Lacquer… lost count.
The table uses a mechanism ordered from AliExpress that folds out to a table. It pops up, and to the left, then the top of the coffee table is rotated over the other “legs” of the mechanism, and it becomes this table. Just high enough to comfortably game from the sofa. (The plywood surface was stained with Minwax Golden Oak and coated in about ten coats of lacquer.)
My goodness. No video?
Seriously I can’t figure out how the table gets that “wide” when its popped up. I figure its just the underside of the “down” coffee table but my brain still no compute.
If I’m understanding the design correctly, the coffee table is two boards folded on each other with a support mechanism hidden inside. When you lift up the table, the mechanism unfolds but the top of the table part goes entirely to one side. You then unfold the top onto the second side of the mechanism. It’s not an automatic unfold.
Well said. Yeah, I was having a hard time describing how it works.
Ahhh that does make a little bit of sense now. Thanks.
That’s wicked cool. Id suggest putting some thin pads on platform where the top rests so you dont ding up the beautiful top
Yeah, I think I’m going to wrap it in felt.
I’ll see what I can do.
I’ll see what I can do.
That’s really beautiful. I’ve been promising to build my wife something like this for over a decade 😅. Hadn’t thought to look on Ali for the mechanical bit!
Stop enabling me! (Thank you)
I’ve been eyeballing those folding table brackets on Ali. How does it seem so far for durability, stability, and pinch points/finger choppage?
Durability seems fine. It’s very stable when up and down. The transition is a bit dodgy, but I have a lot of weight on it. The table top has about a 4" overhang from the base so you’re fingers aren’t really anywhere near the contraption. I’ll try to get a video tomorrow.
Cool I’ll be sure to check it out. I’ve been wanting to make something with one of those brackets but I can’t even trust the adults in my family not to do dumb shit like get stuck in the recliner and somehow simultaneously collapsing the mechanism into itself, seizing it up and snapping off the lever.
That is much cooler than I expected. Looking sharp btw.
Great job!! You do wonderful work.
Looks great
This is sick.
I might look into doing something like this for my apartment. It would actually be small enough ti fit lol
Very cool. Big fan of multifunctional furniture. Well done
I totally dig this! Solid idea and it looks amazing. One modification I made to my lift-top coffee table was boxing in a dedicated spot for storage to prevent anything from straying into the mechanism.
I tried to do something similar, but with touchscreen TV that tilts up (on gas pistons) for arcade mode. My table-top just drops over top to hide it though, so I’m looking your style more (plus the top looks much nicer when folded).
Do you happen to have a video showing how it folds and/or a link to the mechanism? I might end up scrapping mine if yours works better (mines kinda jerry-rigged)
Thanks for that! Looks like it’s OOS - or maybe just not available to my area - but there are similar models from other vendors. Not sure it’ll work for my TV table but one of the variations might do it
😱
This is a game changer!
Great job, looks beautiful!
Really impressive, great job!
so cool!