Since I never understood op-amps from reading or practicing problems I wanted to build a circuit to probe around and use different resistor values to set the amplification.

Currently I am attempting to build an LM358 Non-Inverting Op Amp. I am using my power supply for a +/- 12V rail, and my Arduino Uno for my 5V supply at the V+ input pin. I have chosen two 1k resistors to amplify the signal to 10V at the output and put and led as a indication that the circuit is working.

My questions are as follows:

  1. Is the ground for the voltage rail and input signal the same?
  2. What exactly is wrong with the circuit I built? I want the LED to only turn on when 5V is supplied at the input, right now the LED can turn on if I connect the ground to the voltage rail supply even without an input voltage.
  3. I’ve seen the post on Adafruit with the feedback resistors connected to the same ground as the rail supply, but the circuit diagram does not show where the input voltage ground is? Link: https://blog.adafruit.com/2012/06/13/ask-an-educator-making-a-non-inverting-op-amp-circuit-on-a-breadboard/
  • Link9454@kbin.social
    1·
    1 year ago

    I recommend EEVBlog’s OpAmp tutorial. His explanation is pretty simple to understand. Basically there are two rules (note these rules are ideal, but the exceptions can usually be ignored):

    1. No current flows into the inverting and non-inverting inputs.
    2. For negative and positive feedback circuits, the OpAmp wants to keep the inputs the same by changing its output, and will sink power to its positive or negative power rails to achieve this.