Hey there folks,
I’m trying to figure out how to configure my UFW, and I’m just not sure where to start. What can I do to see the intetnet traffic from individual apps so I can know what I might want to block? This is just my personal computer and I’m a total newbie to configuring firewalls so I’m just not sure how to go about it. Most online guides seem to assume one already knows what they want to block but I don’t even know how/where to monitor local traffic to figure out what I can/should consider blocking.
Unless your ISP provides IPv6 connectivity, which gives every endpoint a globally-routable address. Firewalling at the router only works because of NAT.
That’s why I wrote typical. The question was from a beginner, not a networking expert.