Having a Creality Ender 3 Pro. Have upgraded the mainboard to a new Silent mainboard. Installed this Extroduer and also have a glass bed. I also purchased another glass bed to exchange the scratched one.

What should I do about my problem? Is my only solution to buy a CR-Touch Sensor? How does the sensor even work? Will it also scratch it when I am not careful enough or is it user friendly and fully automated?

I don’t have any other bed except the glas one for now. Should I rather purchase a flexible sheet for the bed instead of a glas bed?

  • scotticus42@lemmy.nz
    link
    fedilink
    arrow-up
    1
    ·
    1 year ago

    Sounds to me like your issue is that the new nozzle now sits lower in relation to the old one. And so now your Z 0 puts the new nozzle tip below where your bed sits.

    Since your not using a probe then all you’ll need to do is move your end stop so it triggers at a higher position, and stops your nozzle from ramming the bed.

    Move the endstop up higher and then let us know if that helps.

    • ReakDuck@lemmy.mlOP
      link
      fedilink
      arrow-up
      1
      ·
      1 year ago

      It did help. Always had not give the stopper a thought that its not hard mounted.